Search This Supplers Products:All - in - one PCmini pcMotherboardPOS MachineDesktop computer hostDiscrete graphics
How to use parallel hard disk and serial hard disk together?
sourcehttps://product.pconline.com.cn
publisherChristine
time2019/01/07
- How to use parallel hard disk and serial hard disk together?
How to use parallel hard disk and serial hard disk together?
How to use parallel hard disk and serial hard disk together? A few days ago, an old computer hard disk of the company failed. The boot squeaked and wanted to add a hard disk as the main disk. However, one hard disk was found to be the serial interface (STAT) and the other was the parallel interface (IDE), but it began to appear. One problem: the computer was originally a serial hard disk, and it was connected to a parallel port.
However, the IDE interface hard disk cannot be recognized on the computer. The bios inside identifies a DVD drive. The serial hard disk is connected to the sata1. According to the general idea, the parallel port hard disk and the serial port hard disk can of course be used together. The condition is that your motherboard There must be an IDE and SATA interface. The first thing to confirm is that the two interfaces of the motherboard are available.
After analysis and search, it is found that the IDE channel setting in the BIOS is off in the initial state, open the save, and set the IDE interface hard disk as the first boot item, the new hard disk is finally installed on the system, and can be used. Then the parallel port hard disk and the serial port hard disk are used together. How do you need to set it up? In fact, everyone has read the above experience and probably knows the answer to this question.
IDE interface and STAT interface Most hard drives can be used, mainly to see if the motherboard has STAT and IDE interfaces. If you find that the hard disk computer can't recognize it, it is likely that the hard disk may be damaged. It may be that the IDE channel in the BIOS is not turned on, or the hard disk partition table boot record is broken and the recognition cannot be started or cannot be started. Need to use hard disk software to fix it.
At present, most of the hard disks we use are serial STA hard disk STAs. In older computers, we can sometimes see the previous parallel hard disk. With the development of science and technology, the parallel hard disk is gradually withdrawing from our sight. Therefore, everyone in the DIY assembly process is currently available for serial hard drives, but as a computer enthusiast we still have to master the relationship between serial hard drives.
